Welcome Our Site

"Park" or the emergency brake assembly in the vehicle in neutral. Lift lid and remove the negative battery ("-"). A jack for the car high enough to lift each wheel near the space to accommodate the frame, use two jack stands. The rear of the vehicle and place the jack to lift each wheel on the jack stands at close range use.Using a tape measure, measure the length of the old speedo cable, removed from the vehicle. The exact length required. Fittings on each end should be similar, so the connection device and the diameter of the coupling device, it will look like a screw cap. Slide under the car with a light in the store. Find box mounted on the transmission cable.

Win all the heat shield or coat of mud, use cable with a plug and remove key. Speedometer cable connection with a clean rag. Metal hook to connect the cable to remove the transfer case, if available, use tweezers on the reins. For the design of screw cap, grasp the top with a pair of pliers and turn counter-clockwise to loosen it. Pull it and watch cable into the square notch. Hands on some thread within the gear housing and insert the screw in the replacement cable Take the other end of the replacement, and turn small square tray. If it does not move, it has been sitting on the cable wire. Finish screwing the nut and tighten with pliers.

Follow the old cable to the front of the vehicle. An electrical outlet and cable clamp holds it in place on the old solution, use a wrench to screw. Slide out the old cable and put the device back into the mountains. A socket support, and tighten the bolt with a key. Push the cable back through the engine compartment, the same way as the old cable. Move up on the firewall under the engine compartment and a cable. A socket and use a wrench to loosen the screw. Slide out the old cable and replace the cable. Replace lid and tighten with a socket and wrench. Pull the cable out and put it back the use of a component.

Shop with light dashboard, driver's side slide down. To look on the board and cable that screws on the back of the speedometer cluster. Using a pair of pliers to open the screw cap and pull it free. If available, from tongs to remove the horseshoe clip. Running in the engine compartment.Old cable that passes through the firewall for a rubber washer, Search. Remove the rubber seal through the hole in the firewall and then pull the old cable through the hole in the firewall. Use a razor cut on one side of the disc, remove the pressure washer. About one or two feet of cable to screw back on the disk, place the new cable. Cable back to the firewall hole, run and press the grommet into the hole in the firewall.

Slide it under the dashboard. To store the light, to explore the use of new cable. Use your fingers to pull the screw on the back of the speedometer housing. Tighten with pliers. Connection to the design, speedometer cable in the housing press and slide the clip down or squeezing with tweezers with hand slot. Jack the vehicle up and remove all ground sockets. Connect the negative battery cable with a socket and wrench. Test drive, and consider the operation of the dashboard speedometer.